Recent content by ManxViking

Hi all. After getting a different pack and fitting it, all issues went away. Therefore the issue must something inside the pack. I am looking for a BMS to try and see otherwise the rest of the pack is now ok and reading correctly with isolation etc. Cheers, David

I bought a 250v/500/1000v resistance tester, not expensive. I have started with each module before, both volts to case and resistance at 500v, then clean and re-test the same and record the results.

Thanks for that. If i have to charge each module, would it not be better to buy a 24v charger of some sort? Or a hybrid inverter to just use as a charger? I hadn't thought about charging several at once as i wasn't sure what the voltage per module maximum was. I don't know if i was to link in...

Thanks MozFromOz. You'll have to forgive my sinicism as I've never done this before and to think I cannot see something which is affecting the module goes against all in my head :) but everyday is a new adventure and we never stop learning so I can tick this off the list. I will try to get at...

You don't think the oxidisation is the issue then? I cant see anything wrong with the tops but I will clean all and then make sure the bottoms cleaned too. Will then retest and update here on if its made a difference or not. David

Thanks Coulomb. The ones that are ok were not exposed to whatever the liquid was in the first 2 sections of the pack. There is no oxidisation or any marking on them at all and they are showing maximum resistance rating compared to the others. My plan is to clean them as much as I can and charge...

Thank you #PVperson. I will reach out this week. Very much appreciated. David

Good afternoon all , Have stripped the pack completely and taken out all 18 modules. 12 of the modules have problems. I have done a resistance test on each module and for the good ones the number rises until it comes to number one, the others when I do an individual test from the positive to the...

I intend on doing exactly that. All modules will need to be charged to the same voltage prior to me rebuilding the pack. Will take me a week or more probably as i only have a small lab power supply to charge with but depends on what voltage I want to balance them to. I'm thinking 40-50% of...

All are disconnected entirely from each other. If I get good readings after dried and cleaned I will just rebuild the pack and try it in the car. Got the car booked in for the paint shop so not a lot of time left to get it going otherwise will have to move the paint dates and lose the slot. I...

Thank you so much #Coulomb. It makes no sense to me as i'm not an electrician but once I have information I can be safe and ok for certain. What confuses me is the different readings as there is no correlation to the voltage numbers i showed on the cardboard in an earlier post. I'm thinking...

Thanks Fred12345 but I don't know how to do that.... David Thank goodness for my 16-year-old son.....

As you can see, module one has a 500 volt resistance of 0.42 to 0.52 MΩ. module 2 has a resistance of 16+, I've done a video and will add to the next message if it's not too big to add. Module 5 was 0.45, module 6 was 16+, module 7 was 0.01. module 8 was 0.005, module 11 was 0.16, module 12 was...

That's a good idea #shpub. I'll logon this evening and do that and download it to my laptop. Perfect ? ? I'm going to remove the 4 worst modules, bring them back to my house to clean and test and charge to a set voltage. I will use the isolation tester to check before removing and confirm all...

#Fred12345 please see what i get when i try to join the R&M MG website Update, Me being dumb again.... Managed to navigate to the correct section.... I think 21 euros for a day with printing rights is ok. Will have to do it from work :) but would have been happier as a download as i could...