Bill Mitchinson
Novice Member
My new MG ZS trophy hybrid is revving very high on some inclines, is this correct. Thanks.
My understanding, based on very dated Toyota Prius designs, is that there isn't a separate generator that "turns on", rather, a motor smoothly transitions from power flowing battery to wheels into power flowing from wheels and engine to battery.The noise you hear is the generator turning on to charge the battery...
But it's not a Toyota, it's an MG.My understanding, based on very dated Toyota Prius designs, is that there isn't a separate generator that "turns on", rather, a motor smoothly transitions from power flowing battery to wheels into power flowing from wheels and engine to battery.
Assuming that's still the case, and I expect that it still is, I don't see how a motor transitioning into the generator area of operation would cause any change in noise.
The petrol engine and associated mechanical shafts, gears, etc. suddenly having to work harder would be a much better candidate, I think. But perhaps that's what you meant.
Sure. But I didn't think that there has been much change in the fundamental hybrid car design since then. I could well be wrong there. It's since occurred to me that the Prius design obviates the necessity for a multi ratio gearbox, and the MG hybrids clearly have a 3-speed gearbox, so there must be something significantly different between the Prius and the MG hybrids.But it's not a Toyota, it's an MG
That "generator" at 45kW sounds a bit like MG1 (Motor Generator 1) in a Prius. I did a quick search for a block diagram for MG hybrids, but found only general diagrams, not specific to MG. I think the problem is that Motor/Generator is a very common term in hybrid powertrain designs, and is commonly abbreviated to MG, the same as Morris Garages. If anyone can find such a diagram, I'd be intetested.Below is the link to the MG site which also mentions the generator.
The ZS Hybrid + and MG3 Hybrid + use the same base drive train It has the standard Petrol ICE alongside a 100kW electric motor for drive. Additionally, it has a 45kW electric generator that charges the hybrid battery as needed twinned with regenerative braking.Sure. But I didn't think that there has been much change in the fundamental hybrid car design since then. I could well be wrong there. It's since occurred to me that the Prius design obviates the necessity for a multi ratio gearbox, and the MG hybrids clearly have a 3-speed gearbox, so there must be something significantly different between the Prius and the MG hybrids.
That "generator" at 45kW sounds a bit like MG1 (Motor Generator 1) in a Prius. I did a quick search for a block diagram for MG hybrids, but found only general diagrams, not specific to MG. I think the problem is that Motor/Generator is a very common term in hybrid powertrain designs, and is commonly abbreviated to MG, the same as Morris Garages. If anyone can find such a diagram, I'd be intetested.
Sometimes one of the motors in a hybrid powertrain is called the Starter Generator, though it also assists with torque production, meaning that it also acts as a motor. Perhaps MG refer to this as the generator.
Its not the generator, it's defintely the engine revving hard as the rev counter jumps to 3600 revs, maybe its because the engine is now having to run the generator AND the car to get it up hill but it's definitely the engine.I suddenly realised while driving up a hill today, and it got louder.
The noise you hear is the generator turning on to charge the battery when the regenerative braking cannot cope, such as going uphill.
The ZS hybrid is a strange, but clever design, but the noise is worrying when you don't realise what causes it.
It's normal our MG has a DHT or dedicated hybrid transmisión, this means electric engine runs to recharge battery leaving Thermic motor with a huge work to keep the speed. A simply solution, a second battery and a recharge-discharge alternate cycle, second battery goes to rescue while primary reloads.Its not the generator, it's defintely the engine revving hard as the rev counter jumps to 3600 revs, maybe its because the engine is now having to run the generator AND the car to get it up hill but it's definitely the engine.
Not great when you're trying to keep the revs under 3000 (as per chinglish manual) and it revs its guts out on a modest hill about 40mph..
It doesnt seem to want to either change up or down.
It doesn't rev this highly doing 70 on the motorway!
Most worrying, hope this is normal.
Graydo
Abslutely agree, but this Atkinson cycle motor gives 128Nm Torque at Max, something i've noticed it's the thermical efficiency which it's preferred by the brand.It would be enough if the combustion engine only drove the wheels when going uphill with an empty battery and also not charged the battery. It's not rocket science for the software to recognize this. If the car notices that you are accelerating hard, charging the battery should simply be interrupted when the battery is empty and only charged again when the load on the combustion engine is reduced.
Sounds like a good solution to me, does it really HAVE to charge the battery on a short incline, surely the car can recognise that it is on a hill and reduce the load on the engine accordingly for a short time.It would be enough if the combustion engine only drove the wheels when going uphill with an empty battery and also not charged the battery. It's not rocket science for the software to recognize this. If the car notices that you are accelerating hard, charging the battery should simply be interrupted when the battery is empty and only charged again when the load on the combustion engine is reduced.
Software PD 052 is now available in UK and Ireland to address this problem.I am getting it on Wednesday. You need to contact your dealership as they will not contact you..Sounds like a good solution to me, does it really HAVE to charge the battery on a short incline, surely the car can recognise that it is on a hill and reduce the load on the engine accordingly for a short time.
Hard to run in a new engine and keep it below 3000 revs when the only option is to slow down considerably annoying other drivers behind, who wonder what the hell you are slowing down for.
Should add that the revs do drop to about 1800 rpm eventually, but it takes a few minutes to do so, is the battery really depleted this quickly, I know its not a Tesla and is only 1.83kw battery but wonder how the power is used up and in what ratio's.
I'll try and bring up the power stats mentioned earlier in this thread, would be very interesting to see just how quickly the battery is depleted/charged, and at what stage of the journey.
Also, how.long regenerative braking takes to put meaningful charge back into the battery at different regen states (1,2 or 3 ).
This cold weather will also have an effect.
I know the salesman said drive, and let the car do its thing but I'm curious to know.
Graydo
Hey BusmanSoftware PD 052 is now available in UK and Ireland to address this problem.I am getting it on Wednesday. You need to contact your dealership as they will not contact you..