Brake Accelerator Pedal Plates

[PremierscfcEV]

I found the brake pedal tight to fit, but at least you know its not going to come off. Just takes perserverance

The accelerator fit is slightly easier but you'll want to get it fit over the top right and left edge so it doesnt slip down when pressing it.

I havent had any issue with mine since fitting and find it really enhances the look. Good luck and post a pic when you're done!

I found the brake pedal the hardest to fit, but it's worth it now they're done.

 

[JeffMcC75]

I found the brake pedal the hardest to fit, but it's worth it now they're done.

Neat! Did you unscrew the plastic foot rest?

EDIT nevermind I see you have an MG ZS

 

[PremierscfcEV]

Neat! Did you unscrew the plastic foot rest?

EDIT nevermind I see you have an MG ZS

No the dead pedal plate just fits on the plastic plate with 3M double sided tape (supplied)

 

[cbowen]

My accelerator cover slipped off. Only noticed when I was struggling to accelerate, looked down and it had half slipped off and was jamming into the carpet. Left it off for now.

 

[JeffMcC75]

My accelerator cover slipped off. Only noticed when I was struggling to accelerate, looked down and it had half slipped off and was jamming into the carpet. Left it off for now.

I did notice that the fitting doesn't grasp top of the accelerator that well. I have been keeping an eye on mine but it seems ok at the moment. You could always try adding an adhesive strip inside.